Autopol Bend Simulator Full Version

the operator can check the tooling in any position and with any tooling set-up and verify the final position of the bending sequence. to avoid any risk of tool clash, the tooling can be adjusted in any position. the operator can verify the final position of the bending sequence.

Autopol Bend Simulator Full Version

the simulation of the bending sequence is based on the 3d model of the part and on the drawing of the part. the tooling used is automatically selected depending on the tooling set-up and the available sections. the bending sequence is performed automatically, and the optimal bending sequence is calculated automatically. it is possible to verify the final bending sequence and to send the final 3d design directly to the cnc.

there is a choice between a hardware bending simulation based on the 3d model and the drawing, a simulation software based on the 3d model only, with the possibility to simulate every bending phase (from the cutting of the blank to the bending of the piece) and a simulation software based on the drawing only. the choice of which software to use is made by the operator on the basis of which it is better to use the 3d model of the part or to use the drawing of the part and the simulation of the bending sequence.

the operator can change the bending sequence and parameters as many times as necessary. thus, the part can be perfectly adapted to the tooling in any position. at the end of the simulation, the optimal bending sequence is calculated automatically, and the tooling used for the bending is automatically selected depending on the available sections and the tooling set-up.

https://www.sogu.com/group/da-jian-kang/discussion/f5f1ceec-7b66-4a73-932f-81b3eaa962a4